One to six offset towers

Maximum operating speed of 800 feet per minute

Motor and drive components sized to needs of the press with all auxiliary equipment installed.

Manual oil lubrication system.

Web break sensors are the non-contact electric eye type.

Hydraulically operated transport dolly for the offset cassettes.

Storage tables for the offset cassettes.

Miyakoshi unwind stand for a 50” diameter mill roll.

Miyakoshi 3” unwind shaft.  Lock up is mechanical by air ratchet.

Magnetic powder brake system for mill roll control on start and stop.

Independent tension control for the unwind.

Controlled tension infeed with electronic Miyascale control system featuring transducer control.

This system automatically monitors and controls the length and stretch of the printed web to an operator selected setting.  All adjustments are made from the operator control station.

Three (3) Rislan covered vibrator rollers.

The vibrators are a rocker arm assembly drive from a rotary input which eliminates the need for individual gear box drive for each vibrator.  This eliminates the possibility of gear streaking and dot slur due to surface speed variation if a vibrator gear box wears or is damaged due to a paper wrap-up. 

The vibrator stroke is fully adjustable from 0” to 1 1\2”.

Two (2) dedicated ink form rollers and one (1) ink/water form roller in the dampener unit.

MIYAFLOW 3 roll continuous dampening system consists of a rubber pan roller, a chromed metering roller and the water/ink form roll.

All ink rollers can be supplied with UV compatible material.

The inker can be silenced by simple pull pin on each offset tower.

Motorized plate cylinder lateral registration is controlled by push button at each offset tower or at the main operator console.

360° circumferential register control is accomplished by harmonic drives on each tower activated by push buttons on each tower or the main operator console.

Letterpress printing and numbering can also be accomplished in a tower by the installation of the proper cassette.

This press is to be equipped with a complete, multiple purpose, process section.  There will be a linear compensator on the infeed side controlled by push button from the operator control station.

Two positions for vertical perforations or slitters.  Each position has its own hardened anvil cylinder and holder shaft. 

One exhaust blower is provided for chad removal for the file hole and marginal punch position and for trim removal from the slitter section.

One cross perforation position with a dedicated hardened anvil cylinder with eccentric on\off.

One position for marginal punching.  The unit will be configured for single-single.  This unit has a manual side adjust.

Miyakoshi press singles folder.  This folder is equipped with external spirals in a dual stream configuration. 

The folder is fully variable with a fold length range of 7” to 22”.  Rated run speed of 800 feet per minute.  Remote Circumferential timing of the chute and spirals is standard.    The unit is equipped with an automatic descending table, reset quantity counter, pack counter and a spray marker for pack ending.

Reinsertion system from Miyakoshi is available.

Web guide

Digital Web Roll Diameter Detector (DDS-100)

File Punch Position

Second cross perforation position.

Rewinders of 24” 40” or 50” are available.

Miyakoshi piggyback sheeter with a rated run speed of 500 feet per minute can be supplied as an option.  This sheeter is cassette style and sets on top of the rewind stand.  The sheeter will be equipped with a linear compensator before the infeed section.  This unit is designed to accommodate the various register systems available in the market.  All sheet sizes are with a change gear configuration.  The sheeter will be set for single stream application. 

Miyakoshi vibrating jogger will be provided with the sheeter.